Chucking Tools

Male Revolving Centres
These are manufactured as per ISI 3793-1966 standards of Male Point, Female Point and Triple Bearings Heavy Duty, Carbide Tipped

Quick Change Chuks
These are manufactured as per ISI 7824-1975 standards, made from case hardening steel.


APPLICATION : In continuous flowing productions where one operation is carried out after the other in sequence like drilling, reaming, tapping, counterboring, camfering etc. Primarily used on Radial Drilling machines. Can also be used on ordinary Drilling machines, Tapping machines, Milling machines, Capstan and Turret Lathes etc.

ADVANTAGE : The conventional method of tool change is to use drill drifts / ejectors. There is ample loss of time by this method since the machine has to be stopped, the tool to be removed and the next tool to be mounted. However using the quick change chuck it is a matter of seconds before the tool is changed. The machine is not even required to be stopped.

Carbied Tipped Revolving Centres
It allows better penetration into the wood, reduces problems with splitting. Plain Dead Centre - Half & Full. Carbide Dead Centres - Grade 'A' & Grade ' B ' Half & full. Grade' A' Carbides are made from sinter hipping process which will last much more than Grade ' B ' Carbides which are made from conventional vacuum furnaced process.

Tube (Pipe) Revolving Centres
It is available in two types: plain center blunt and plain center pointed . In turning / grinding of pipes and tubes which cannot be held by ordinary Revolving Centers because of small point diameters of Revolving Centers.

Collets for Quick Change Chucks
Made from case hardening steel and is used for drilling operations. These collet chucks motivate the collet by pulling the collet back into a tapered spindle. As the collet is pulled back, the tapered spindle causes the collet to close down to clamp the work part.  In this type of collet chuck there is no work part length control.  If the work part size changes, the linear location of the part will change.

Cylindrical Plain Plug Gauge
Progressive cylindrical plug gauge have the Go and No Go stepped on a single gauge member so parts can be quickly inspected in one operation. Plain plug gauges can be used to set cylinder bore gauges, air gauges, and internal micrometers. By using the same size master ring gauges, lead errors on measurements can be eliminated.

Special features

• Length steps
• Pilot for easy entry 
• Reduced diameters
• Grooves
• Polygons
• Clearance to gauge lobbing 

Plain Dead Centres
These are manufactured according to ISI 2289-1976 standards.

Plain dead centers are available in full (male), half (male), full (female), half (female). Plain dead centers are constructed of bearing steel and fully hardened to permit insistent regrinding.

According to the company special dead centers can be manufactured as per the demand, requirement and specifications of the customer. They are also accessible with spanner flats and draw off nut.

Female Revolving Centres
It is made from high grade steel, these centres are manufactured with an exceptional standard to give years of trouble-free use. These accessories make this a highly versatile system which will cater for almost every demand. The set also includes a useful ejection tool to remove the various heads.